Note Viewer

If we were to do the telescoping design and assuming that the robot would fit under the spinny thingy/at the 26in mark while lying flat in the robot. Then the design should probably only require two stages if the robot length is greater than 30inches.

Current protypes that in the works:

1. telescoping climber that doesn't require constant force springs. in the previous notes there should be the teams whose design its based off.

2. unfolding climber based on 2363 2016 climber. Their CAD is available and most of the parts for that protoype has been gathered and I would say that the prototype is half built is Laura finsihed the motor mount.
 

not really, except people are getting sick, including me

1. finish the unfolding climber, it really is close to completion. You should be able to download the CAD from this link.

https://www.chiefdelphi.com/t/team-2363-cad-uploads/154501

2. start building the climber that doesn't require the springs

yes