Note Viewer

Not going to test 1" compression, and probably not 1.5", just test 2" and maybe more if wanted (in .5" increments), should be quick to route if needed.

• Routed fingers for the shooter
• assembled shooter gearbox
• generated CAM for shooter side plates
• printed hex adapters and hub for fairlane wheel

None

• Determine which wheels to test and put them on the BOM along with other needed parts that aren't already in the shop!
• Route side plates for the shooter (CAM file is loaded into the router, stock is on G54)
• CAD, slice and print spacers for shooter
• Assemble shooter (if above are finished)
• Shooter from the summer project:
  • cut longer hex shaft
  • two shooting wheels in the middle with shaft collars
  • attach belt
  • start shooting - device some SAFETY steps first!!!!
  • adjust the angle and compression by re-positioning the polycarbonate hood (MEASURE and drill new holes), play with rpms, one wheel, two wheels, add weight (flywheel) etc. The balls are surprisingly sticky BTW.

Yes